Protekt AZ411 anchorage cable 10 m

Protekt AZ411 anchorage cable with fall indicator 10 m

The Protekt AZ411 is a 10-metre anchorage cable for forming a temporary anchor point. Manufactured from PVC-coated galvanised steel cable, the device is suitable for the simultaneous fall protection of up to three users in installation configurations approved by the manufacturer. As the longest version in the AZ411 range, it is suited to large structures and applications requiring extended reach.

Key features

• Designed for the simultaneous protection of up to three users
• 10-metre length for large or more distant supporting structures
• Galvanised steel cable with a protective PVC coating
• Aluminium end loops suitable for pass-through installation
• Integrated fall indicator reacts to an instantaneous force of approximately 3–4 kN
• Suitable for horizontal or vertical installation on a load-bearing structural element in accordance with the manufacturer's instructions

Applications

The AZ411 is suitable for forming a temporary anchor point around a load-bearing beam, column or another suitable structural element. The 10-metre version provides the reach needed to wrap around large structures or connect where a shorter anchorage cable cannot reach the intended anchor location.

The cable may also be used as an attachment component with a LifeLiner anchorage system, for example when the anchor line needs to be raised above floor level to reduce wear. Compatibility and the correct installation method must be verified using the instructions for both the AZ411 and the LifeLiner system.

Fall indicator

The fall indicator integrated into the AZ411 end loop deforms, bends or breaks when subjected to an instantaneous force of approximately 3–4 kN. This is the activation level of the indicator, not the breaking strength of the anchorage cable. If the indicator is damaged or deformed, the complete AZ411 must be removed from service and replaced.

Safety and compliance

The Protekt AZ411 complies with EN 795:2012 Type B and CEN/TS 16415:2013. It may be used by up to three people simultaneously only in installation configurations approved by the manufacturer.

When the device forms part of a fall arrest system, each user must be equipped with a system that limits the dynamic force applied during fall arrest to no more than 6 kN. The effect of the long cable on system positioning, potential movement and required clearance must be considered when designing the complete system.

The strength of the supporting structure, positioning of the cable and compatibility of the complete system must be verified before use. The product is not intended for lifting loads.

Technical specifications

• Manufacturer: Protekt
• Model: AZ411
• Manufacturer reference: AZ411 100
• Product type: anchorage cable with integrated fall indicator
• Length: 10 m
• Cable material: galvanised steel
• Coating: PVC
• End loop material: aluminium
• Cable diameter: 6.3 mm
• Maximum number of users: 3 people
• Minimum static strength: 14 kN in the direction of loading
• Maximum service load transmitted to the structure: 10 kN
• Fall indicator activation level: approximately 3–4 kN
• Standard: EN 795:2012, Type B
• Multi-user specification: CEN/TS 16415:2013

Inspections and service life

The AZ411 must be inspected before every use and undergo a detailed periodic inspection by a competent person or an authorised service centre at least every 12 months. The manufacturer does not specify a fixed maximum service life for a correctly functioning device. Continued use depends on operating conditions, frequency of use and the condition of the product. Equipment that has arrested a fall, is damaged or fails an inspection must be removed from service.