Protekt AT192100 roof anchor device for timber steel concrete
- Product Code: AT192
Protekt AT192100 is a 1 m anchor device for steep roofs and for connecting fall protection equipment to a structural anchorage point. The product is intended for single-user fall protection applications requiring compliance with EN 795:2012 (Personal fall protection equipment. Anchor devices).
General information
AT192 is a Type A anchor device used as a connecting element between fall protection equipment and a structural anchor point. Its main functional benefit is the flexible steel wire rope construction, which allows installation on steep roof structures according to the manufacturer’s instructions.
The product is not a fall arrest device by itself and must be used as part of a compatible fall protection system.
Technical data
- PRODUCT TYPE: anchor device for steep roofs
- MODEL: Protekt AT192100
- LENGTH: 1 m
- USER CAPACITY: 1 person
- CERTIFICATION: EN 795:2012 (Personal fall protection equipment. Anchor devices), Type A
- STATIC STRENGTH: minimum 12 kN
- WIRE ROPE: stainless steel ANSI 316, diameter 5 mm, 7 x 19 construction
- HANDLE: galvanized steel
- TIMBER FIXING: rafter or beam, minimum 80 x 80 mm
- WOOD SCREWS: diameter 8 mm or 10 mm, length 100–400 mm
- WOOD SCREW TORQUE: 8 Nm
- STEEL FIXING: M12 screws, at least stainless steel class A2-70
- CONCRETE FIXING: M12 mechanical anchors
- CONCRETE REQUIREMENT: compressive strength at least 20 MPa
- CONNECTION: EN 362 (Personal protective equipment against falls from a height. Connectors) compliant connector
- SERVICE LIFE: 5 years, followed by manufacturer inspection
- INSPECTION INTERVAL: at least every 12 months
Installation on timber, concrete and steel
AT192 can be fixed to timber structures according to the manufacturer’s instructions when the rafter or beam size is at least 80 x 80 mm. Installation on a glulam beam is possible when the structure and fixing meet the specified requirements.
The product can also be fixed to steel structures with M12 screws and to concrete substrates with M12 mechanical anchors, provided that the substrate requirements are met.
Advantages and differences compared to similar products
- Suitable for steep roof applications requiring a structural connecting anchor.
- Can be installed on timber, steel or concrete according to the manufacturer’s instructions.
- Steel wire rope construction enables connection over roof structures without a rigid anchor post.
- Single-user design for personal fall protection systems.
Applications
Protekt AT192100 is suitable for steep roof fall protection installations where the anchor device is fixed to a rafter, glulam beam, steel structure or concrete substrate.
The product is not intended for lifting loads, simultaneous use by more than one person, or use as a standalone fall arrest device. The anchor point should be positioned above the user, and required clearance must be checked before use.
Q & A
- Can AT192 be screwed to timber: yes, according to the manual, to a rafter or beam with a minimum size of 80 x 80 mm.
- Can AT192 be fixed to a glulam beam: yes, if the beam and fixing meet the manufacturer’s requirements.
- Can AT192 be fixed to steel: yes, with M12 screws and at least A2-70 class fasteners.
- Can AT192 be fixed to concrete: yes, with M12 mechanical anchors, when the concrete compressive strength is at least 20 MPa.
- Availability: availability is indicated separately on the product page.
Delivery information
Delivery methods, lead time and store availability are indicated separately on the product page.
